| Content Your BMW 3 series car
- Introduction
- Safety first!
- Troubleshooting an emergency
- Starting the engine from an additional power source
- Wheel replacement
- Towing
- Leak detection
- Weekly checks
- Checks under the hood of the car
- Engine oil level
- Coolant level
- Level of a brake liquid and a working liquid of coupling
- Power steering fluid
- Electrical systems
- Tire condition and air pressure
- Battery
- Working fluids and lubricants
Instruction manual - Overview of the dashboard, warning lights and devices
- Controls
- Cruise control system
- Air conditioning system with manual control and automatic operation
- Storage bays and other interior components
Regular maintenance and maintenance - gasoline engines - Introduction
- Regular maintenance
- TO-2
- Resetting maintenance interval (CBS) display mode
- Maintenance of front brakes
- Maintenance of rear brakes
- Car inspection
- Replacement of air filter
- Replacement of spark plugs
- Brake fluid replacement
- Checking and replacing the auxiliary drive belt
- Replacing the fuel filter
- Replacing coolant
Regular maintenance and maintenance - diesel engines - Introduction
- Regular maintenance
- TO-2
- Resetting maintenance interval (CBS) display mode
- Maintenance of front brakes
- Maintenance of rear brakes
- Car Inspection
- Replacement of the air filter (keys 2/5)
- Replacing the main fuel filter
- Replacing the particulate filter
- Brake fluid replacement
- Checking and replacing the auxiliary drive belt
- Changing the coolant
Procedures for repairing a four-cylinder petrol engine without removing it from the engine compartment - General information
- Compression check - description and explanation
- Determination of the top dead center for the cylinder 1 piston
- Cylinder head cover - removal and installation
- Torsion damper / pulley and crankshaft pulley hub - removal and installation
- Chains of drive timing - removal, inspection and installation
- Asterisks and timing chain tensioner - removal and installation
- Phase Shifter - description and replacement of components
- Camshafts and pushers
- Cylinder head - removal and installation
- Crankcase - removal and installation
- Front frame reinforcement - removal and installation
- Front subframe - lowering, removal and installation
- Balancing shafts - general information
- Oil pump - removal, inspection and installation
- Oil seals - replacement
- Handwheel / drive clutch plate - Removing and installing
- Centering Crankshaft Bearing - Replacement
- Engine / gearbox mountings - check and replace
- Engine oil level and pressure sensors
Procedures for repairing a six-cylinder petrol engine without removing it from the engine compartment - General information
- Compression check - description and explanation
- Determination of the top dead center for the cylinder 1 piston
- Cylinder head cover - removal and installation
- Torsional vibration damper - removal and installation
- Chain of drive timing - removal, inspection and installation
- Components of the valve timing system (Vanos) - removal, inspection and installation
- Camshafts and pushers
- Components of the Valvetronic system - removal and installation
- Cylinder head - removal and installation
- Crankcase - removal and installation
- Oil pump - removal, inspection and installation
- Oil seals - replacement
- Handwheel / drive clutch plate - removing and installing
- Engine / gearbox mountings - flywheel guide bearing - check, remove and install
- Engine oil level and pressure sensors
Repair procedures for the diesel engine (M47T2 and M57T2) without removing it from the engine compartment - General information
- Compression check - description and explanation
- Engine assembly / valve timing - general information and usage
- Cylinder head cover - removal and installation
- Crankshaft pulley / torsional vibration damper - Removing and installing
- Camshafts, rocker arms and hydraulic lifters - removal, inspection and installation
- Cylinder head - removal and installation
- Crankcase - removal and installation
- Oil pump - removal, inspection and installation
- Balancing shaft assembly - removal and installation
- Oil cooler - removal and installation
- Crankshaft oil seals - replacement
- Handwheel / drive clutch plate - Removing and installing
- Engine supports - checking and replacing
- Flywheel guide bearing - check, remove and install
- Chains for timing and cover - removal and installation
- Engine oil level and pressure sensors
Repair procedures for the diesel engine (N47 and N57) without removing it from the engine compartment - General information
- Compression check - description and explanation
- Engine assembly / valve timing - general information and usage
- Cylinder head cover - removal and installation
- Crankshaft pulley / torsional vibration damper - removing and installing
- Camshafts, rocker arms and hydraulic lifters - removal, inspection and installation
- Cylinder head - removal and installation
- Crankcase - removal and installation
- Oil pump / vacuum pump - removal, inspection and installation
- Balancer shaft assembly - general information
- Oil cooler - removal and installation
- Crankshaft oil seals - replacement
- Handwheel / drive clutch plate - Removing and installing
- Engine supports - checking and replacing
- Flywheel guide bearing - check, remove and install
- Chains of drive timing and cover - general information
- Engine oil level and pressure sensors
Removing the engine from the engine compartment and the overhaul procedure - General information
- Major engine repairs - general information
- Engine removal - methods and precautions
- Engine - removal and installation
- Engine overhauling - sequence of disassembly
- Cylinder head - disassembly
- Cylinder head and valves - cleaning and checking
- Cylinder head - assembly
- Piston / connecting rod assembly - removal
- Timing drive chain (diesel engines N47 and N57) - removal and installation
- Crankshaft removal
- Cylinder block / crankcase - cleaning and inspection
- Piston / connecting rod assembly - check
- Crankshaft check
- The crankshaft bearing and thrust bearing - check
- Overhauling - assembly sequence
- Piston rings - installation
- Crankshaft - installation
- Pistons / connecting rods in assembly - installation
- Engine - operation after major repairs
Cooling system, heater and ventilation system - General information and precautions
- Cooling hoses - detach and replace
- Radiator - removal, inspection and installation
- Thermostat - removal and installation
- Cooling fan and viscous coupling - removal and installation
- Electric cooling fan and casing - Removing and installing
- Electrical sensors for the cooling system - checking, removing and installing
- Water pump - removal and installation
- Heater and ventilation system - general information
- Components of the heater / ventilation system - removal and installation
- Air conditioning system - general information and precautions
- Components of the air conditioning system - removal and installation
- Heating element for auxiliary heater - removal and installation
- Shutters and servomotor for adjusting the intensity of the radiator airflow - removal and installation
The power supply and exhaust system - gasoline engines - General information and precautions
- Air filter assembly - removing and installing
- Fuel tank - removal and installation
- Accelerator pedal - removal and installation
- Fuel injection system - general information
- Fuel injection system - pressure relief and refueling
- Fuel pump / fuel level sensors - Removing and installing
- Fuel injection system - check and adjustment
- Throttle body - removing and installing
- Components of the distributed fuel injection system - removal and installation
- Collectors - removal and installation
Exhaust system - removal and installation - Power and exhaust system - diesel engines General information and precautions
- Air filter assembly - removing and installing
- Fuel tank - removal and installation
- Accelerator pedal - removal and installation
- Fuel injection system - general information
- Fuel injection system - pressure relief and refueling
- Fuel pump / fuel level sensors and control unit - removal and installation
- Fuel injection system - check and adjustment
- High-pressure fuel pump (fuel pump) - Removing and installing
- Fuel injectors - removal and installation
- Components of the electronic engine management (EDC) - removal and installation
- Turbocharger - description and precautions
- Turbocharger - removal and installation
- Turbocharger - check and overhaul
- Intercooler - removing and installing
- Collectors - removal and installation
- Exhaust system - general information and replacement
Control systems for harmful emissions - General Information
- Emission control systems (gasoline engines) - checking and replacing components
- Emission control systems (diesel engines) - checking and replacing components
- Catalytic converter - general information and precautions
Starting and recharging systems - General information and precautions
- Detection of malfunctions in the electrical system - general information
- Battery - check and charge
- Storage battery - detachment, removal and installation
- Charge system - check
- Generator drive belt - removal, installation and tension
- Generator - removal and installation
- Generator - check and overhaul
- Startup system - check
- Starter - removal and installation
- Starter - check and overhaul
- Preheating system for diesel engines - description and verification
- Glow plugs - removal, inspection and installation
- Control unit / relay for pre- and post-heating systems - removal and installation
Ignition system - General information and precautions
- Ignition system - check
- High-voltage ignition coils - removal and installation
- Detonation sensor - removal and installation
Clutch - General information
- Clutch assembly - removal, inspection and installation
- Clutch release bearing and lever - removal, inspection and installation
- The working cylinder - removal, check and installation
- Master cylinder - removal, inspection and installation
- Hydraulic clutch circuit - pumping
- Clutch pedal - removal and installation
Manual transmission - General information
- Checking the transmission oil level
- Replacing gearbox oil
- Components of the gearshift mechanism - removal and installation
- Oil seals - replacement
- Switch for reversing lights - check, remove and install
- Manual gearbox - Removing and installing
- Major overhaul of a manual transmission - general information
Automatic transmission - General information
- Selector lever - removal and installation
- Cable of the selector lever - removal, installation and adjustment
- Oil seals - replacement
- Automatic gearbox - removal and installation
- Overhaul of an automatic transmission - general information
- Electronic components / sensors - removal and installation
- Checking the automatic transmission fluid level
- Automatic transmission replacement
Main drive, drive shafts and driveshaft - General information
- The main gear assembly is removal and installation
- Seals of the final drive assembly - replacement
- Drive shafts - removal and installation
- Anthers of drive shafts - replacement
- Drive shaft - removal and installation
- Rubber coupling propshaft - check and replace
- PTO shaft bearing - checking and replacing
- Universal joints of the propshaft - check and replace
- Checking the final drive oil level
Brake system - General information
- Hydraulic system - air removal
- Hydraulic connections and hoses - replacement
- Front brake pads are replacement
- Rear brake pads - replacement
- Front brake disc - check, remove and install
- Rear brake disc - check, remove and install
- Front brake caliper - removal, overhaul and installation
- Rear brake caliper - removal, overhaul and installation
- Master brake cylinder - removal, overhaul and installation
- Brake pedal - removal and installation
- Vacuum brake booster - checking
- The check valve of the vacuum amplifier of brakes - removal, check and installation
- Parking brake - adjustment
- Parking brake lever - removal and installation
- Parking brake cables - removal and installation
- Parking brake shoes - removal and installation
- Stop light switch - removal and installation
- Anti-lock braking system (ABS) - general information
- Anti-lock components - removal and installation
- Vacuum pump - removal and installation
Suspension and steering - General Information
- Front hub assembly - removal and installation
- Front tail-vise of swivel pin - removal and installation
- Front pillar - removal, overhaul and installation
- Front levers / rack - removal, overhaul and installation
- Ball joint for front lever - replacement
- Front anti-roll bar - removal and installation
- Connecting rod of the stabilizer of cross-section stability - removal and installation
- Rear hub assembly - replacement
- Rear hub bearing replacement
- Rear shock absorber - removal, overhaul and installation
- Rear helical spring - removal and installation
- Shaft of rear swivel pin - removal, overhaul and installation
- Rear levers / racks - removal, overhaul and installation
- Rear anti-roll bar - removal and installation
- Steering wheel - removal and installation
- Steering column - removal, inspection and installation
- The mechanism for locking the steering column - general information
- Intermediate shaft of the steering column - removal and installation
- Rack-and-pinion steering gear assembly - removal, overhaul and installation
- Power steering pump - removal and installation
- Hydraulic power steering circuit - pumping
- Active Steering control unit - removal and installation
- Rubber anthers of the steering rack - replacement
- Tips of transverse steering rods / ball joints - removal and installation
- The cross-section steering draft - replacement
- Dynamic stability control (dsc) - general information and component replacement)
- Wheel alignment angles - general information
Body structure and components - General information
- Maintenance - body and frame
- Maintenance - upholstery and rugs
- Elimination of minor body damage - repairs
- Removing serious body damage - general information
- Front bumper - removal and installation
- Rear bumper - removal and installation
- Hood - removal, installation and adjustment
- Hood opening cable - removal and installation
- Hood lock - removal and installation
- Doors - removal, installation and adjustment
- Internal door trim panels - removal and installation
- Handle and door lock components - removal and installation
- Glass lifters and regulator - removal and installation
- Lid / tailgate and support pillars - Removing and installing
- Components of the lid / tailgate lock - removal and installation
- Components of the central lock - removal and installation
- Components of electric glass lifts - removal and installation
- Mirrors and related components - removal and installation
- Windshield and rear window - general information
- Hatch - general information, servo replacement and initialization
- Exterior elements of the body - removal and installation
- Seats - removal and installation
- System of pretensioners of seat belts - general information
- Safety belt components - removal and installation
- Internal cladding panels - removal and installation
- Central console - removal and installation
- Fixing panel assembly - removal and installation
Electrical equipment and electrical systems - General Information
- Detection of malfunctions in the electrical system - general information
- Fuses and relays - general information
- Switches - removal and installation
- Lamps (external lighting) - replacement
- Lamps (interior lighting) - replacement
- External headlamps - removal and installation
- Adjusting the height of the headlights - general information
- Dashboard - removal and installation
- Components of the instrument panel - removal and installation
- Rain sensor - removal and installation
- Suspension height sensor - removing and installing
- Tire pressure monitoring system indicator - general information
- Acoustic signal - removal and installation
- Wiper arm - removal and installation
- Draft and wiper drive - removal and installation
- Components of the windshield washer system / headlights - removal and installation
- Audio system unit - removal and installation
- Speakers - removal and installation
- Radio antenna - general information
- Cruise control system - general information and component replacement
- Anti-theft system - general information
- Components of the heated front seats - removal and installation
- Airbag System - General Information and Precautions
- Components of the airbag system - removal and installation
- Parking assist system (PDC) - general information and component replacement
- Electrical diagrams - general information
Applications - Dimensions and weight
- Vehicle identification numbers
- General repair procedures
- Lifting the car with a jack, the points of the pillars
- Tools and devices
- Checking the technical condition of the car
- Troubleshooting
|