Скачать книгу - Ford Escape / Ford Maverick / Mazda Tribute with 2003, book repair in eBook


Content

Instruction manual

  • Dashboard
  • Controls and interior equipment
  • Seats and elements of the passive safety system
  • Starting the engine
  • Driving a car
General Information
  • About this guide
  • Cars Ford Escape, Mazda Tribute and Ford Maverick
  • Vehicle identification numbers
  • Acquisition of spare parts
  • Methods of service, tools and work equipment
  • Lifting the jack and towing a car
  • Starting an engine from an auxiliary battery
  • Translation of decimal values ??in inches to values in millimeters
  • Conversion factors
  • Safety first!
  • Service fluids and lubricants
  • Determining the causes of malfunctions
Daily Care and Maintenance
  • Ford Escape and Mazda Tribute car service schedule
  • Introduction
  • General recommendations for car care
  • Checking the levels of service fluids and lubricants (every 400 km or weekly)
  • Checking the condition and tire inflation pressure (every 400 km or weekly)
  • Replacement of engine oil and oil filter (every 4800 km or once every three months)
  • Inspection and replacement of windshield wiper blades (every 12,000 km or once every six months)
  • Inspection, maintenance and charging of the battery (every 12,000 km or every six months)
  • Checking the cooling system (every 12,000 km or every six months)
  • Rearrangement of the wheels (every 12,000 km or once every six months)
  • Inspection of seat belts (every 12,000 km or every six months)
  • Inspection and replacement of hoses that are in the engine compartment (every 24,000 km or once a year)
  • Checking the technical condition of the braking system (every 24,000 km or once a year)
  • Checking the technical state of the steering and suspension (every 24,000 km or once a year)
  • Checking the technical condition of the fuel system (every 24,000 km or once a year)
  • Checking the transmission oil level in the manual transmission (every 24,000 km or once a year)
  • Checking the level of the transmission fluid in the transfer case (every 24,000 km or once a year)
  • Checking the condition and replacing the air filter (every 24,000 km or once a year)
  • Inspection of drive shaft covers (every 24,000 km or once a year)
  • Checking the technical condition of the exhaust system (every 48,000 km or every two years)
  • Replacing the fuel filter (every 48,000 km or every two years)
  • Maintenance of the cooling system (coolant draining, flushing and filling) (every 48,000 km or every two years)
  • Replacement of the brake fluid (every 48,000 km or every two years)
  • Checking the condition and replacing the drive belt (every 48,000 km or every two years)
  • Replacing the transmission fluid of the automatic transmission (every 48,000 km or every two years)
  • Changing the oil of the manual transmission (every 48,000 km or every two years)
  • Replacing differential oil (4WD versions) (every 48,000 km or every two years)
  • Changing the fluid in the transfer case (4WD versions) (every 48,000 km or every two years)
  • Replacement of the crankcase ventilation valve (PCV) - 4-cylinder engines (every 96,000 km or every four years)
  • Inspection and replacement of spark plugs (check intervals are shown in the maintenance schedule)
  • Checking the status of the ignition coil (V6 engines) (every 96,000 km or every four years)
  • Inspection and replacement of spark plug wires - 4-cylinder engines (every 96,000 km or every four years)
Four-cylinder engine
  • General Information
  • Repair procedures that can be performed without removing the engine from the engine compartment
  • Determination of the top dead center for the cylinder piston No1
  • Cylinder head cover - removal and installation
  • Valve clearance - check and adjustment
  • Intake manifold - removal and installation
  • Exhaust manifold - removal and installation
  • Crankshaft Pulley - Removing and installing
  • Timing belt (2.0 liter engines) - removal, inspection and installation
  • Timing Chain Cover, chain and tensioner - Removing and installing
  • Front engine oil seals - replacement
  • Camshafts and pushers - removal, inspection and installation
  • Cylinder head - removal and installation
  • Crankcase - removal and installation
  • Oil pump - removal, inspection and installation
  • Flywheel - removal, inspection and installation
  • Main rear seal
  • Engine supports - checking and replacing
The V6 engine
  • General information
  • Car repair without removing the engine from the engine compartment
  • The top dead center (TDC) of the piston of the first cylinder is the location
  • Valve mechanism covers - removing and installing
  • Intake manifold - removal and installation
  • Exhaust manifolds - removal and installation
  • Pulley and front crankshaft seal - removal and installation
  • Front engine cover - removal and installation
  • Drive chains, tensioners and guides - removal, inspection and installation
  • Camshafts, hydraulic expansion joints and rocker arms - removal, inspection and installation
  • Cylinder heads - removing and installing
  • Pallet - removal and installation
  • Oil pump - removal, inspection and installation
  • Rear main engine oil seal - replacement
  • Drive disk - removal and installation
  • Engine mountings - inspection and replacement
Major engine repairs
  • General information
  • Checking the oil pressure
  • Compression check in engine cylinders
  • Diagnosis with measurement of the degree of dilution
  • Alternative methods of engine restoration
  • Engine removal - methods and precautions
  • Engine - removal and installation
  • Engine overhauling - sequence of disassembly
  • Pistons / connecting rods - removal and installation
  • Crankshaft - removal
  • Engine overhaul - assembly sequence
  • The first start-up and engine break-in after major overhaul
Cooling, heating and air conditioning systems
  • General information
  • Antifreeze - general information
  • Thermostat - check of working capacity and replacement
  • Engine cooling fans - functionality and replacement check
  • Expansion tank - removal and installation
  • Radiator - removal and installation
  • Cooling pump - performance test
  • Cooling pump - removing and installing
  • Coolant temperature sensor - operation and replacement test
  • Resistor and electric motor of the heater fan - replacement
  • Control panel for heating and air conditioning - removal and installation
  • Heater - replacement
  • Air conditioning and heating systems - operation and maintenance check
  • Air conditioning compressor - removal and installation
  • The filter - the dehumidifier of an air conditioning system - removal and installation
  • Condenser for air conditioning - removal and installation
  • Compressor clutch cycle switch - replacement
  • Drainage pipe of air conditioning system - removal and installation
  • Lube oil cooler - removing and installing
Fuel and exhaust system
  • General information and precautions
  • Pressure relief in the fuel system
  • Fuel pump / fuel pressure check
  • Fuel lines and their couplings - general information
  • Fuel pump / fuel level sensor - Removing and installing
  • Fuel tank - removal and installation
  • Cleaning and refueling the fuel tank - general information
  • Air cleaner - removal and installation
  • Throttle cable - removal, installation and adjustment
  • Multipoint fuel injection (MFI) - general information
  • Fuel injection system - general condition check
  • Throttle unit - inspection, removal and installation
  • Extinguisher of fuel pulsation - removal and installation
  • Fuel receiver and nozzles - removal and installation
  • Exhaust system - inspection and replacement of elements
Engine electrical systems
  • General information, precautions and battery disconnection
  • Battery - emergency start from external battery
  • Battery - inspection, removal and installation
  • Battery cable replacement
  • Ignition system - general information
  • Ignition system - prevention
  • Ignition coils - replacement
  • Charging system - general information and precautions
  • Charge system - prevention
  • Generator - removal and installation
  • Launch system - general information and precautions
  • Starter and its electrical circuit - status check
  • Starter - removal and installation
Exhaust gas control and engine control systems
  • General information
  • On-board diagnostic system (OBD) and DTCs
  • The camshaft position sensor (CMP) is a replacement
  • Clutch pedal position sensor (CPR) - replacement
  • Crankshaft position sensor (TFR) - replacement
  • Cylinder head temperature sensor (CST) - replacement
  • Coolant temperature sensor (ECT) - replacement
  • Detonation sensor - replacement
  • Airflow meter (MAF) - replacement
  • The sensor of rotation of the secondary shaft (OSS) - replacement
  • Oxygen sensors - general information and replacement
  • Hydraulic power steering system pressure sensor (PSP) - replacement
  • Throttle position (TP) sensor - replacement
  • Selector lever (TR) - replacement and adjustment
  • Turbine shaft speed sensor (TSS) - replacement
  • Vehicle speed sensor (VSS) - replacement
  • Engine control module (PCM) - replacement
  • Idle valve (IAC) - replacement
  • Catalytic converters
  • Fuel vapor recovery system (EVAP) - general description and replacement of elements
  • The EGR system is a general description and replacement of elements
  • Crankcase ventilation system (PCV) - general description and replacement of elements
Manual transmission
  • General information
  • Gear lever - removal and installation
  • Shift mechanism (2WD) - removal and installation
  • Cables for gear change (4WD) - removal and installation
  • Transmission oil seals - replacement
  • Manual gearbox - removing and installing
  • Repair manual transmission - general information
  • Transmission supports - replacement
Automatic transmission
  • General information
  • Diagnosis - general information
  • Selector lever - replacement
  • Selector cable - replacement and adjustment
  • Additional cooler - removal and installation
  • Automatic gearbox - removal and installation
  • Automatic transmission repair - general information
Transfer case
  • General information
  • Rear transmission output shaft o-ring - removal and installation
  • Drive shaft oil seal (right) - removing and installing
  • Transfer case - removal and installation
  • Mode switch
Clutch and transmission
  • General information
  • Clutch - description and verification
  • Clutch master cylinder - removal and installation
  • Clutch slave cylinder - removing and installing
  • Hydraulic clutch system - pumping
  • Clutch elements - removal, inspection and installation
  • Releaser and clutch fork - removal, inspection and installation
  • Drive shafts - removal and installation
  • Drive shaft cover - replacement
  • Cardan shaft - removal and installation (all-wheel drive vehicles)
  • Seals of the rear axles (all-wheel drive vehicles) - replacement
  • Differential (all-wheel drive vehicles) - removal and installation
Brake system
  • General information
  • Anti-lock braking system - general information
  • Disc brake pads - replacement
  • Disc brake caliper - removal and installation
  • Brake disc - inspection, removal and installation
  • Brake shoe pads - replacement
  • Service brake cylinder - removal, repair and installation
  • Master cylinder - removal and installation
  • Hoses and pipes of brake system - inspection and replacement
  • Hydraulic braking system - pumping
  • Vacuum brake booster - performance check, removal and installation
  • Parking brake - adjustment of the mechanism
  • Stop light sensor - replacement
Suspension and steering
  • General information
  • Shock absorber (front) - removal, inspection and installation
  • Suspension and suspension spring - replacement
  • Stabilizer of lateral stability (front) and its bushings - removal and installation
  • Suspension lever (front) - removing, inspection and installation
  • Rotary fist and hub - removal and installation
  • Hub and bearing (front) - Removing and installing
  • Shock absorber (rear) - removal, inspection and installation
  • Suspension levers (rear) - removal and installation
  • Spring of suspension (rear) - removal and installation
  • Hub and bearing (rear) - removal and installation
  • Steering wheel - removal and installation
  • Steering column - removal and installation
  • Tips of steering rods - removal and installation
  • Power Steering Pads - Replacement
  • Steering gear - removal and installation
  • Power steering pump - removal and installation
  • Hydraulic power steering system - pumping
  • Hydraulic power steering system cooling system cooler
  • Wheels and tires - general information
  • Wheel alignment angles - general information
Car body
  • General information
  • Body - service
  • Vinyl cladding - maintenance
  • Upholstery and carpets - maintenance
  • Body repair - minor damage
  • Body repair - serious damage
  • Loops and locks - maintenance
  • Wind and fixed glass - replacement
  • Hood cover - removal, installation and adjustment
  • Latch and bonnet bonnet cable - removal and installation
  • Bumpers - removal and installation
  • Front wing - removal and installation
  • Radiator grille - removal and installation
  • Interior liner and chute - removal and installation
  • Facing panels of doors - removal and installation
  • Doors - removal, installation and adjustment
  • Latch, lock cylinder and door handle - removal and installation
  • Glasses of door windows - removal and installation
  • Lift - removal and installation
  • Mirrors - removal and installation
  • Rear hinged door - removal, installation and adjustment
  • Remote actuator, latch of the folding door and its windows - removal and installation
  • Central console - removal and installation
  • Dashboard cover
  • Covers of a casing of a steering column - removal and installation
  • Instrument panel - removal and installation
  • Seats - removal and installation
Electrical equipment of a car
  • General information
  • Determining the causes of faults in electrical circuits - general information
  • Fuses and inserts - general information
  • Circuit breakers - general information
  • Relay - general information and validation
  • Circuit breaker / hazard warning light interrupter - operation check and replacement
  • Switch and ignition lock cylinder - replacement
  • Switches located on the steering column - replacement
  • Switches located on the dashboard - replacement
  • Instrument panel - removal and installation
  • Windshield wiper motor - operation check and replacement
  • Car radio and speakers - Removing and installing
  • Antenna and its cable replacement
  • Rear window heater - performance check and repair
  • Headlamp bulbs - replacement
  • Headlights - adjustment
  • Headlights - replacement
  • Signal replacement
  • Replacement of lighting fixtures
  • Side mirrors with electric drive - description
  • Speed-keeping system - description
  • Power windows - description
  • Automatic door locks - description
  • Daylight-saving lighting (DRL) - general information
  • Airbag system - general information and precautions
  • Wiring diagrams - general information
Alphabetical index