Найти книгу: "Quality Engineering in Manufacturing Technology"

Rizzoni is designed for the sophomore/junior level, Introduction to Electrical Engineering course required for non-EE majors. The most widely used book for this course, Rizzoni introduces non-majors to the three basic areas of electrical engineering: circuits, electronics, and electromechanics. The second edition continues the tradition of focusing on the topics and issues of interest to the non-electrical engineering student. To maintain student interest in these topics, Rizzoni provides numerous links between electrical engineering and other engineering fields.

Хорошая книга для инженеров-нефтяников. В книге подробно рассматриваются физические основы нефте и газо разработки.

Content

Introduction

Planning and design

Rob tool kit

Welding

"Dog Bowl"

The rear of the fuel tank

The bed seat

Installing the wing

Air filter cover

Exhaust pipes

Production of the wing

Spoiler

The manual is intended for the 5th year students of the Polymer Faculty of 020015 «Chemical Technology» course. The manual reflects the current state of the elastomers science and production technologies. The focus is on technological methods, based on the scientific understanding of the chemistry in the synthesis of general-purpose and special rubbers, their properties and applications.The content of the manual corresponds to the program of the course «Technology of Elastomers». Published by the decision of the Editing and Publishing Board of Kazan National Research Technological University

Учебное пособие соответствует Государственному образовательному стандарту по направлению 240100 – «Химическая технология» и программе «Наука о полимерах и технология». В пособии описаны пластмассы на основе полимеров, получаемых путем полимеризации, поликонденсации, и химически модифицированные полимеры (подготовка мономера, полимеризация или поликонденсация, свойства, переработка и применение)